Solution

Hello,everyone.Welcome to stay tuned to the SPT Laser. The current setting of laser tube in laser machining is introduced today. ... [Detail]

2022-09-29

CO₂ laser tube is one of the parts that needs to be replaced after certain time, it can be half a year to 3 years. In general situations, CO₂ laser tubes’service life is about a year and a half .Due to various irregular operating habits and incorrect use, the CO ₂ laser tube’s "premature death" is not rare. This will undoubtedly have an impact on the production of thecompany and increase the cost. ... [Detail]

2021-06-24

Recently, the weather is getting hotter and the average temperature is about to exceed 34°C. With intermittent rain, the humidity in the air also has been greatly increased. This environment is undoubtedly fatal to laser equipment that requires water cooling during operation.In hot and humid environment, it is easy to cause condensation inside the laser equipment during the operation, the performance of the laser tube or the RF laser may be affected,and even serious damage may be caused. ... [Detail]

2021-05-05

Heating generated from laser can absorb dirtto contaminate the surface of optical lens. Dust, oil vapour, water vapour, splashing of materials during cutting and engraving, fingerprints and so on can also contaminate the optical lens. It will decrease the transmittance of laser lens, cause laser process power drop and lens damage. ... [Detail]

2020-04-24

In winter, the air temperature is close to 0℃ in many areas all over the world. If the ambient temperature is too low, it may result in water freezing inside the co2 glass laser tube and water chiller, end up with laser tube broken and damages to chiller. If you can’t remember to dry the laser tube and chiller every time when you shut down the machine, you may need some solution for anti freezing of coolant. ... [Detail]

2017-06-29

After working for some time, there will be a large amount of dirt(such as the impurities in cooling water, dust, or microorganism) adhere to the inner wall of co2 laser tube. The dirt that adhere to the inner wall prevents the water coolant taking away the heat from the tube, so that the power will be lower, and beam quality will not be good enough. Or worse, the laser tube will breaking totally because of the heat. ... [Detail]

2015-08-06